Eldes EKB3 Manuale di Installazione Scaricare il pdf (Pagina 140)

140

140 EN

MANUAL ELDES ESIM264 V3.1

ATTENTION: At least 1 battery must be removed if the device is not in use.

ATTENTION: In order to avoid re or explosion hazards, the system must be used only with approved battery. Special care must be

taken when connecting positive and negative battery terminals. Dispose old batteries only into special collection sites. Do not charge,

disassemble, heat or incinerate old batteries.

NOTE: The system sends an SMS message to a preset User 1 as soon as the battery level runs below 5%.

NOTE: The battery status can be monitored in real-time using ELDES Conguration Tool software.

32.7.5. Restoring Default Parameters

1. Remove any battery from EWS2.

2. Press and hold the RESET button.

3. Insert the battery back to EWS2.

4. Hold the RESET button until LED indicator provides several short ashes.

5. Release the RESET button.

6. Parameters restored to default.

32.8. EW1B - Battery-Powered Wireless Zone & PGM Output Expansion Module

Main EW1B features:

• 2 zones for wired sensor connection;

• 2 PGM outputs for electrical appliance connection.

Wireless expansion module EW1B is a wireless device with 2 zones and 2 PGM outputs. This expansion module connects to ELDES wireless

alarm systems and enables wireless access for to 2 wired devices such as movement PIR sensors, magnetic door contacts etc. In addition it

allows to connect and control up to 2 appliances, i.e. lighting, heating etc. After the wiring process to EW1B it is necessary to bind EW1B to the

alarm system by sending a corresponding command via SMS text message or using software ELDES Conguration Tool. t is possible to connect

up to 16 EW1B devices to ESIM264 alarm system at a time. The maximum wireless connection range is 150 meters (in open areas).

32.8.1. Technical Specications

32.8.1.1. Electrical & Mechanical Characteristics

Battery Type 1,5V Alkaline AA type

Number of Batteries 3

Battery Operation Time ~18 months

Number of Zones 2

Zone Connection Type Normally closed (NC)

Number of PGM Outputs 2

EW1B PGM Output Circuit

1 R

OUT

Open Collector Output.

Output is pulled to COM

when turned ON.

Maximum Commuting PGM Output Values Voltage – 30V; current 500mA

Wireless Transmitter-Receiver Frequency 868 MHz

Wireless Communication Range Up to 30 meters in premises; up to 150 me-

ters in open areas

Compatible with Alarm Systems ELDES Wireless

Range of Operating Temperatures -20...+55ºC

EW1B PCB Dimensions 38x60x12mm

EW1B Enclosure Dimensions 90x110x40mm

Humidity

0-90% RH @ 0... +40 °C (non-condensing)

Enclosure rating IP65

* The operation time depends on dierent conditions and may vary.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 167 168

Commenti su questo manuale

Nessun commento

Eldes EKB3 Manuale di Installazione Pagina 140

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Eldes EKB3